HP Latex 300 Series

Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Reseat/replace Curing Control Sensors cable.
2. Reseat/replace Temp. sensor 1.
SE Code: 16.12:10 – Curing System: Temperature sensor 2 failure or not connected
Problem description:
Temperature sensor 2.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
▲
Reseat/replace Temp. sensor 2.
SE Code: 16.13:10 – Curing System: Temperature sensor 3 failure or not connected
Problem description:
Temperature sensor 3.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
▲
Reseat/replace Temp. sensor 3.
SE Code: 16.14:10 – Curing System: Temperature sensor 4 failure or not connected
Problem description:
Temperature sensor 4.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
▲
Reseat/replace Temp. sensor 4.
SE Code: 16.31:10 – Curing system: Fan 1 fault
Problem description:
ENWW Continuable and non-continuable error codes 97