7. Remove one screw T-10 screw (Type C) that secures the PZ cable holder to the Vacuum Beam.
8. Repeat step 7 for the other PZ cable holder.
9. Unclip the Ink Collector Sensor Cable from each switch.
10. Unclip the Ink Collector Sensor Cable from the PCA.
Vacuum rubbers
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Remove the Right cover on page 246.
2. Remove the
Left cover on page 249.
3. Remove the removable print zone (see the ink collector section in the user’s guide).
394 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
