Continuable and non-continuable error codes
Some of the error codes are continuable, which means you can press Enter on the front panel and continue
working with the printer. Non-continuable error codes do not allow you to continue working with the printer,
in this case power the printer off and on again and see whether the system error disappears. If the error code
reappears, then the printer requires an on-site visit in order to resolve the problem.
IMPORTANT: If the solution calls for a replacement part, replace one component at a time and check if the
error has been cleared before replacing another component. Using this procedure you will be able to
determine exactly which component has failed.
SE Code: 01.0:10 – Engine PCA electronics error. The main Engine PCA component is
not responding
Problem description:
Engine PCA damaged or wrongly connected. Connector on the formatter damaged (very low probability).
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Replace the engine PCA board (95% probabilities). See
Engine PCA on page 433.
2. If the problem persist, replace the formatter PCA board (very low probability). See
Formatter PCA
on page 430.
SE Code: 01.1:10 – Printmech electronics error
Problem description:
Printmech PCA.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Reseat/Replace Printmech to Formater PCA Cables.
2. Replace the Printmech PCA. See
PrintMech PCA on page 433.
3. Replace the Formatter PCA board (very low probability). See
Formatter PCA on page 430.
SE Code: 01.2:10 – ISS1 PCA problem
Problem description:
Printmech to ISS1 PCA cable Main PSU to Printmech PCA cable ISS PCA Printmech PCA.
Corrective action:
Call agent:
70 Chapter 3 System error codes ENWW
To Next Page
Loading...
