NOTE: After installing the NEW Static Front Platen, perform the following Service Calibration:
●
Substare Advance Calibration — See
4.1.1 Substrate-Advance Calibration on page 178
●
OMAS Calibration — See
4.1.2.1 Print Calibration Pattern on page 179
Static front platens (330)
Removal
1. Remove the
Right cover on page 246.
2. Remove the
Left cover on page 249.
3. Move the Carriage Assembly fully to the right.
4. Remove 152 T-10 screws (Type C) that secure the static front platen to the Vacuum Beam.
ENWW Static front platens (330) 381
To Next Page
Loading...
