SE Code: 25.7:10 – Bad contact detected in ISS slot K floater
Problem description:
Malfunction or sensor failure: A PIP glitch or a presence error has been detected. Automatic diagnostic should
discard if it's a recoverable failure or not.
Corrective action:
Service engineer:
1. Remove the black ink cartridge and reinstall it into the printer.
2. Replace the black ink cartridge.
Service engineer:
1. Check that the ISS to black ink cartridge cable is not damaged and is correctly connected to the Ink
Supply Tubes PCA.
2. Replace the ISS to black ink cartridge cable.
SE Code: 25.8:10 – Malfunction or sensor failure
Problem description:
A PIP glitch or a presence error has been detected. Automatic diagnostic should discard if it's a recoverable
failure or not
Corrective action:
Service engineer:
▲
Replace the PIP.
SE Code: 26.01:10 – Broken Bag. M (PIP 1)
Problem description:
Magenta Ink Cartridge: A broken bag has been detected in the ink cartridge. This error must be solved and the
printer checked and cleared of this error code before the printer can resume printing.
Corrective action:
Service engineer:
1. Remove the ink cartridge and check for any ink leaking from the cartridge. In some extreme cases:
●
Ink can leak from the damaged ink cartridge and contaminate the pressurized air system, or;
●
Air can get inside the Ink System causing bubbles in the Ink Tubes, which can damage the
printheads.
2. For this issue perform the ”
3.3.2 Recover Broken Bag on page 151” Diagnostic procedure.
3. If the ISS Bottom PCA has been damaged by ink, and cannot be repaired; it must be replaced.
SE Code: 26.02:10 – Broken Bag. LM (PIP 2)
Problem description:
Light Magenta Ink Cartridge: A broken bag has been detected in the ink cartridge. This error must be solved
and the printer checked and cleared of this error code before the printer can resume printing.
ENWW Continuable and non-continuable error codes 111
To Next Page
Loading...
Need help?
General
