8. Remove the Impinging Recirculation Cover carefully in order to avoid damage to the scan-axis encoder.
Be careful with all cables on the left side.
IMPORTANT: Be careful with cables during reassembly. There are cables all along and they can be trapped
by the ribs in the cover.
Impinging heater module
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Open the Window. See Opening the window on page 313.
2. Remove the Right impinging module cover on page 252.
3. Remove the
Left impinging module cover on page 251.
4. Remove the
Impinging pressure sensor on page 264.
268 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
