HP Latex 300 Series

Call agent:
▲
Restart the printer.
Service engineer:
1. Check that the PrintMech to Interconnect Power cable is not damaged.
2. Check that the PrintMech to Interconnect Power cable is correctly connected to the PrintMech PCA and
the Interconnect PCA.
3. Replace the PrintMech to Interconnect Power cable (which is included in the Electronics Module Cable
Kit).
SE Code: 17.3:11 – Main PCA to PrintMech Black 1 cable does not seem to be
connected
Problem description:
Main PCA to PrintMech Black 1 cable is damaged Main PCA damaged.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Check that the Main PCA to PrintMech Black 2 cable is not damaged.
2. Check that the Main PCA to PrintMech Black 2 cable is correctly connected to the Main PCA and the
PrintMech PCA.
3. Replace the Main PCA to PrintMech Black 2 cable.
SE Code: 17.4:11 – Main PCA to PrintMech White 2 cable does not seem to be
connected
Problem description:
Main PCA to PrintMech White 2 cable is damaged Main PCA damaged.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Check that the Main PCA to PrintMech White 2 cable is not damaged.
2. Check that the Main PCA to PrintMech White 2 cable is correctly connected to the Main PCA and the
PrintMech PCA.
3. Replace the Main PCA to PrintMech White 2 cable.
SE Code: 21:03 – Service Station electrical current limit
Problem description:
Electrical current limit.
ENWW Continuable and non-continuable error codes 103