20. Remove the Carriage Stopper from the printer.
21. Slide the Carriage Assembly (including the belt) to the right and out of the printer.
22. If the Carriage Assembly is to be replaced, make sure that you remove the Belt, the Carriage PCA, Color
Sensor, Encoder and Line Sensors and the Cutter Assembly (in order to install them on the new Carriage
Assembly).
NOTE: After installing the NEW Carriage Assembly, perform the following:
●
“5.5.1 Scan-Axis Calibration”.
●
“5.6.1 Line Sensor Calibration”.
Ink supply tubes and trailing cable
Removal
WARNING! Turn off the printer and disconnect both power cords.
CAUTION: You MUST NEVER replace both the Hard Disk Drive and the ISS PCAs (or the Ink Supply Tubes and
Trailing Cable) at the same time. If these parts need to be replaced, you MUST first replace one part and then
power ON the printer until it completely initializes. Then power OFF the printer and replace the other part.
1. Remove the Right cover on page 246.
2. Remove the
Left cover on page 249.
3. Remove the
Top cover on page 254.
4. Remove the
Rear cover on page 253.
5. Remove the
Right connector cover on page 258.
6. Remove the ink supplies.
ENWW Ink supply tubes and trailing cable 375
To Next Page
Loading...
