Press OK to continue with the test.
3. The printer will move the cleaning roll of megacassette and will ask to check visually if it was advanced
correctly. Press OK to repeat the test or Cancel to exit.
4. After exit from the test, the front panel asks if the spit rolls turned or not. Press OK for yes or Cancel for
no.
If Cancel is pressed, because both spit rolls did not turn correctly, the test failed and needs to revise the
system.
If OK is pressed, because both spit rolls turned correctly, the diagnostic result is successful. Press OK to
finish the test and restart the unit.
6.6 Service Station Check Distance
Description
The purpose of this test is to check the service station distance.
Procedure
1. Go to Diagnostic tests > 6. Service station Menu > 6.5 Service Station Check Distance.
2. The front panel will display the various electrical subsystems being initialized in order to perform the
test. The front panel asks to:
●
Lower the lever.
Press OK to continue with the test.
3. After, check the distance, the front panel displays the result of the test. Press OK to finish the test and
restart the printer.
7. Covers Menu
7.1 Cover/Switch Sensor
Description
The printer checks the functionality of the window sensor.
Procedure
1. Go to Diagnostic tests > 7. Covers Menu > 7.1 Cover/Switch Sensor.
2. The test asks to close the window. Do so, and press OK.
3. The test asks for open the window. Do so, and press OK.
4. Close the window, and press OK.
5. The front panel display the diagnostic result. Press OK to finish the test.
8. Diagnostic Utilities Menu
8.1 Force Normal Start
Description
This selection must be made after you no longer want the printer to start up in diagnostic mode. After this
selection is made the printer will start up as normal.
ENWW Diagnostic Menu 161
To Next Page
Loading...
