EasyManua.ls Logo

HP Latex 300 Series

HP Latex 300 Series
478 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Corrective action:
Service engineer:
1. Remove the ink cartridge and check for any ink leaking from the cartridge. In some extreme cases:
Ink can leak from the damaged ink cartridge and contaminate the pressurized air system, or;
Air can get inside the Ink System causing bubbles in the Ink Tubes, which can damage the
printheads.
2. For this issue perform the ”
3.3.2 Recover Broken Bag on page 151” Diagnostic procedure.
3. If the ISS Bottom PCA has been damaged by ink, and cannot be repaired; it must be replaced.
SE Code: 26.03:10 Broken Bag. LC (PIP 3)
Problem description:
Light Cyan Ink Cartridge: A broken bag has been detected in the ink cartridge. This error must be solved and
the printer checked and cleared of this error code before the printer can resume printing.
Corrective action:
Service engineer:
1. Remove the ink cartridge and check for any ink leaking from the cartridge. In some extreme cases:
Ink can leak from the damaged ink cartridge and contaminate the pressurized air system, or;
Air can get inside the Ink System causing bubbles in the Ink Tubes, which can damage the
printheads.
2. For this issue perform the ”
3.3.2 Recover Broken Bag on page 151” Diagnostic procedure.
3. If the ISS Bottom PCA has been damaged by ink, and cannot be repaired; it must be replaced.
SE Code: 26.04:10 Broken Bag. C (PIP 4)
Problem description:
Cyan Ink Cartridge: A broken bag has been detected in the ink cartridge. This error must be solved and the
printer checked and cleared of this error code before the printer can resume printing.
Corrective action:
Service engineer:
1. Remove the ink cartridge and check for any ink leaking from the cartridge. In some extreme cases:
Ink can leak from the damaged ink cartridge and contaminate the pressurized air system, or;
Air can get inside the Ink System causing bubbles in the Ink Tubes, which can damage the
printheads.
2. For this issue perform the ”
3.3.2 Recover Broken Bag on page 151” Diagnostic procedure.
3. If the ISS Bottom PCA has been damaged by ink, and cannot be repaired; it must be replaced.
SE Code: 26.05:10 Broken Bag. OP (PIP 5)
Problem description:
112 Chapter 3 System error codes ENWW

Table of Contents

Other manuals for HP Latex 300 Series

Related product manuals