Moisture on the printer
Users should use the printer in an environment between 20% and 80% relative humidity. To recover from
moisture condensation, turn the printer off, and, using the main roller as a reference, wait until the printer is
completely dry before using it again.
Belt swelling
To prevent new belts from swelling incorrectly, keep them in their bags with desiccant until you need to
install them.
Clean the printer
To maintain the printer in good operating condition, keep it free of dust accumulation, ink, and other
contamination. Cleaning intervals are determined by the printer environment and by the types of printer
supplies used.
Clean the exterior of the printer
See the user’s guide.
Cleaning the drive roller
CAUTION: Prevent water or other liquids from running onto electrical components or circuits, or through
openings in the Electronics Module.
1. Perform the Turn Drive Roller Utility. Refer to 1.3.1 Turn Drive Roller on page 166.
2. Open the window and apply any common household cleaning solution (water based only) to a soft, lint-
free rag and apply it to the Drive Roller while it is rotating. Make sure that you thoroughly clean the
Drive Roller.
3. Press Enter when you have completed the cleaning procedure.
4. Allow the Drive Roller to dry before loading substrate in to the printer.
Clean the platen
See the user’s guide.
Clean the substrate-advance sensor window
See the user’s guide.
Clean and lubricate the carriage rail
See the user’s guide.
Clean the encoder strip
See the user’s guide.
ENWW Moisture on the printer 445
To Next Page
Loading...
