Carriage flex cables
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Remove the Right cover on page 246.
2. Remove the
Front panel on page 244.
3. Remove the
Primer assembly on page 341.
4. Press the two sides of the Carriage PCA Cover and unclip from the Carriage Assembly.
5. Use a flat bladed screwdriver to release ALL the clips, securing the Carriage Flex Cables to the Carriage
Assembly, by pulling upwards.
6. Disconnect the ALL the Flex Cables from the Carriage PCA.
7. Remove eight T-8 screws (Type L) that secure the Carriage Flex Cables to the Carriage Assembly.
368 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
