Procedure
▲
Go to Service Menu > 2. Image Quality Prints > 2.2 Printhead Alignment > 2.2.4 Manual PH Alignment
Menu > 2.2.4.2 Manual Alignment Settings.
2.3 Substrate Advance Menu
2.3.1 Substrate Advance Adjustment
Description
The purpose of the Print Adjustment Plot is to help you in determining the advance offset in the printer with
the current substrate loaded. This value can be found after printing the
Advanced alignment diagnostic print
on page 194, then it has to be introduced in the RIP.
Procedure
▲
Go to Service Menu > 2. Image Quality Prints > 2.3 Substrate Advance > 2.3.1 Print Adjustment Plot.
2.4 Printhead Health Menu
2.4.1 Print Test Plot
Description
The purpose of this Service plot is to show the overall health of the printhead nozzles by visual inspection.
Refer to Chapter 5 for detailed information.
Procedure
▲
Go to Service Menu > 2. Image Quality Prints > 2.4 PH Health > 2.4.1 Print Test Plot.
2.4.2 Advanced Test Plot
Description
The purpose of this Service plot is to help in identifying which of the printhead nozzles are failing. Refer to
Chapter 5 for detailed information.
Procedure
▲
Go to Service Menu > 2. Image Quality Prints > 2.4 PH Health > 2.4.2 Advanced Test Plot.
2.4.3 Only for Escalations
Description
Service plot for escalations to HP Division upon request. Refer to
Plot for escalation only on page 196.
Procedure
▲
Go to Service Menu > 2. Image Quality Prints > 2.4 PH Health > 2.4.3 Only for Escalations.
2.5 Geometry Check
Description
The purpose of this Service plot is to provide a template for checking the printer’s length accuracy and figure
distortion. Refer to
2.5 Geometry Check on page 175.
Procedure
▲
Go to Service Menu > 2. Image Quality Prints > 2.5 Geometry Check.
ENWW Service Menu 175
To Next Page
Loading...
