HP Latex 300 Series

Service engineer:
1. Check that OMAS sensor is connected to OMAS Controller Card.
2. Replace the OMAS Controller Card.
SE Code: 50.3:11 – Main PCA to OMAS Controller cable does not seem to be
connected
Problem description:
The cable from Main PCA to OMAS controller has a problem.
Corrective action:
Service engineer:
▲
Restart the printer.
Service engineer:
1. Check that the Main PCA to OMAS Controller cable is not damaged.
2. Check that the Main PCA to OMAS Controller cable is correctly connected to the Main PCA and the OMAS
Controller Card.
SE Code: 50.4:11 – OMAS Controller to PrintMech PCA cable does not seem to be
connected
Problem description:
OMAS Controller to PrintMech PCA cable does not seem to be connected.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Check that the OMAS Controller to PrintMech PCA cable is not damaged.
2. Check that the OMAS Controller to PrintMech PCA cable is correctly connected to the PrintMech PCA and
the OMAS Controller Card.
SE Code: 50.5:11 – OMAS board: SENSOR_NOT_CONNECTED
Problem description:
OMAS sensor not connected.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
124 Chapter 3 System error codes ENWW