5. Remove five T-20 screws that secure the Right Rollfeed.
6. Carefully remove the Right Rollfeed sufficiently to gain access to the Substrate Lever Sensor.
7. Unclip the Substrate Lever Sensor from the mounting lugs on the Right Rollfeed.
Ink Collector sensor
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Remove the Right cover on page 246.
2. Remove the
Left cover on page 249.
3. Remove the removable print zone (see the ink collector section in the user’s guide).
ENWW Ink Collector sensor 391
To Next Page
Loading...
