Incorrect readings from substrate encoder.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Perform Substrate Drive diagnostics.
2. Replace the Encoder Disc and Sensor. See
Encoder disc and sensor on page 385.
SE Code: 56:10 – Substrate Encoder calibration failed
Problem description:
Substrate Encoder calibration failed .
Corrective action:
Service engineer:
1. Perform Substrate Drive diagnostics.
2. Replace the Encoder Disc and Sensor. See
Encoder disc and sensor on page 385.
SE Code: 58.1:10 – Color sensor Shutter Actuator failure
Problem description:
Color sensor Shutter Actuator failure.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Replace the Color sensor Shutter Actuator Assembly.
2. Perform the Color sensor Shutter Diagnostic Test to ensure that there is no other problem preventing
shutter operation.
3. Perform a Color sensor basic test (CLC) to ensure that the replaced part is working correctly.
SE Code: 58.2:10 – Color sensor Shutter Deactivator failure
Problem description:
The Color sensor Shutter Deactivator fail.
Corrective action:
Service engineer:
1. Check that the Shutter Deactivator is correctly screwed into place.
2. Perform the Color sensor Shutter Diagnostic Test to ensure that there is no other problem preventing
shutter operation.
3. Perform a Color sensor basic test (CLC) to ensure that the replaced part is working correctly.
ENWW Continuable and non-continuable error codes 127
To Next Page
Loading...
Need help?
General
