HP Latex 300 Series Service Manual

11. Tighten the T-20 screw that secures the linkage to the spring.
Individual pinchwheel rollers
NOTE: If you need to replace the whole pinchwheel assembly, see Pinchwheel assembly on page 403.
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Remove the Rear cover on page 253.
2. Raise the substrate lever.
3. Remove the interpinches close to the individual pinchwheel affected.
ENWW Individual pinchwheel rollers 411

HP Latex 300 Series Specifications

General

Brand	HP
Model	Latex 300 Series
Category	Printer
Language	English