●
HP Bright White Paper
●
HP Premium Instant Dry Gloss Paper
●
HP Premium Instant Dry Photo Satin Paper
●
HP Universal Coated Paper
●
HP Universal Heavyweight Coated Paper
2. Go to Service Menu > 1 Service Utilities > 1.6 Carriage Menu > 1.6.2 ESP Measurement Test.
3. The front panel displays information about the Spectrophotometer installed in the printer.
The manufacturing date is shown in YYWW format, where YY is the year and WW is the week of
manufacturing.
4. The substrate is advanced 4 inches to cover the platen, and then the Spectrophotometer is used to
measure paper white at five different positions along the scan axis. The measured Lab values are
averaged and displayed.
5. Compare the values from the front panel with the expected results for the loaded substrate type.
If, for example, the value seen for L is 93 when HP Bright White Paper is loaded, this would indicate that
the Spectrophotometer is functioning correctly. The test itself does not detect whether the values are
within the expected results.
1.6.3 Test Cutter
Description
The purpose of this service utility is to check that the Cutter works properly.
Procedure
1. Go to Service Menu > 1 Service Utilities > 1.6 Carriage Menu > 1.6.3 Test Cutter.
2. Make sure that substrate is loaded, then press OK to proceed with the test.
3. The printer advances the substrate, prepares the Cutter, and tries to cut the substrate.
4. When it has finished cutting, the printer disengages the Cutter.
5. The front panel asks you to confirm that the Cutter has cut the substrate.
1.7 Service Station Menu
1.7.1 Maintenance Cartridge
1.7.1.1 Cleaning Roll Detection
Description
The purpose of this service utility is to check if level of usage of web wipe can be read.
Procedure
▲
to Service Menu > 1 Service Utilities > 1.7 Service Station Menu > 1.7.1.1 Cleaning roll detection.
1.8 Heating and Curing Menu
1.8.1 Curing System Monitor
Description
ENWW Service Menu 171
To Next Page
Loading...
Need help?
General
