HP Latex 300 Series Service Manual

10. Remove five T-10 screws from below the Output Platen edge.
11. Lift the Output Platen off the locating pins and remove.
Installation
NOTE: To ensure the Impinging Module is properly secured to its brackets insert and tighten the far right
screw first.
Input roller
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Raise the right lever to release the right hand end of the Input Roller.
290 Chapter 8 Removal and installation ENWW

HP Latex 300 Series Specifications

General

Brand	HP
Model	Latex 300 Series
Category	Printer
Language	English