HP Latex 300 Series Service Manual

Primer fault.
Corrective action:
Call agent:
1. Check that the Primer Arm is not damaged and there are no obstacles in its way.
2. Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
Service engineer:
▲
Replace the Primer Assembly. See
Primer assembly on page 341.
SE Code: 46:13 – Primer test distance failed
Problem description:
Primer encoder is damaged. Primer cable is damaged. Interconnect PCA is damaged (very low probability).
PrintMech PCA is damaged (very low probability).
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Check that the Primer Arm is not damaged and there are no obstacles in its way.
2. Check that Primer cable is not damaged and correctly connected to the Interconnect PCA.
3. Replace the Primer Assembly. See
Primer assembly on page 341.
4. Replace the PrintMech PCA. See
PrintMech PCA on page 433.
5. Replace the Interconnect PCA. See
Interconnect PCA on page 429.
SE Code: 50:01 – OMAS Module communication failure
Problem description:
OMAS communication failure.
Corrective action:
Call agent:
▲
Check that the printer has the latest firmware version. If not, update the firmware to the latest version.
Service engineer:
1. Check that the OMAS Controller to OMAS Sensor cable is not damaged and is correctly connected to the
OMAS Controller Card and the OMAS Module.
2. Replace the OMAS Module. See
OMAS on page 399.
SE Code: 50:03 – OMAS Controller to PSU cable does not seem to be connected
Problem description:
The OMAS controller power cable does not seem to be connected.
122 Chapter 3 System error codes ENWW

HP Latex 300 Series Specifications

General

Brand	HP
Model	Latex 300 Series
Category	Printer
Language	English