7. Turn on the printer and let it initialize normally. It will not request new firmware.
8. Connect the printer to the customer’s network, and retrieve the IP address.
9. Install the new firmware using the Embedded Web Server. See the user’s guide.
10. Perform printhead alignment, substrate-advance calibration, and color calibration.
Heater control assembly fan
WARNING! Hazardous moving parts: rotating fan blades. Keep hands clear.
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Remove the left connector cover.
2. Remove the heater control assembly fan by gently pulling it from three rubber stand-offs.
3. Disconnect the heater control assembly fan cable.
Installation
1. Remove the four screws from the old heater control assembly fan.
422 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
