SE Code: 08.04:1 – ASERT in front panel code
Problem description:
It appears when there is a firmware error and front panel is not able to communicate with the rest of the
printer.
Corrective action:
Call agent:
1. Press Enter and continue.
2. Update the firmware.
SE Code: 08.08 – Application crash in the front panel side
Problem description:
Application crash in the front panel side.
Corrective action:
Call agent:
1. Press Enter and continue. Try the last operation again.
2. Switch the power off at the rear of the printer, wait briefly, then switch it back on again.
3. Update the firmware.
SE Code: 08.10 – Front Panel not connected or damaged. It appears when the there
is a communication error with the device. It might be a hardware error or front
panel unplugged
Problem description:
Front Panel not connected or damaged.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Ensure the front panel is properly connected.
2. Ensure the front panel cable is properly fitted in the Formatter.
3. Replace the Formatter. See
Formatter PCA on page 430.
4. Replace the front panel. See
Front panel on page 244.
SE Code: 11.10 – Trailing Cable does not seem to be connected
Problem description:
Trailing cable not correctly connected or damaged.
Corrective action:
Call agent:
ENWW Continuable and non-continuable error codes 75
To Next Page
Loading...
