Corrective action:
Call agent:
▲
Switch the power off at the rear of the printer, wait briefly, then switch it back on again.
Service engineer:
▲
Replace Formatter. See
Formatter PCA on page 430.
SE Code: 05.5:10 – BIOS should be updated (advisory)
Problem description:
HDD replacement with FW requiring newer Formatter BIOS.
Corrective action:
Service engineer:
▲
Perform a Formatter BIOS update via the diagnostics menu.
SE Code: 06:03 – NVM file has bad CRC
Problem description:
NVM file has bad CRC.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again.
2. Use the Hard disk recovery in Diagnostic test.
3. Replace the Hard Disk Drive.
SE Code: 06:10 – Main NVM failure: not detected, read/write failed or readback
error
Problem description:
Main NVM not detected, read/write failed or readback error.
Corrective action:
Call agent:
▲
Restart the printer.
Service engineer:
1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again.
2. Use the Hard disk recovery in Diagnostic test.
3. Replace the Hard Disk Drive.
74 Chapter 3 System error codes ENWW
To Next Page
Loading...
Need help?
General
