Roller gear protector
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Remove the Right cover on page 246.
2. Remove the
Left cover on page 249.
3. Remove the
Right connector cover on page 258.
4. Remove the
E-box extension on page 260.
5. Remove the
Service station on page 348.
6. Remove the
Ink Supply Station (ISS) on page 355.
7. Remove the
Substrate-axis motor on page 383.
8. Remove the
Encoder disc and sensor on page 385.
9. Remove the
Drive roller on page 240.
10. Raise the substrate lever.
11. Remove the T-20 screw that secures the linkage to the spring.
396 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
