4. Remove the T-8 screw that secures the lubrication felts from the left side of the carriage assembly.
5. Remove the lubrication felts.
Floater and PIP assembly
NOTE: The following procedure involves handling of ink tubes. You are recommended to protect areas
around the repair zone to avoid undesired ink stains, and to wear gloves and protective clothes.
Removal
WARNING! Turn off the printer and disconnect both power cords.
1. Remove the Left cover on page 249.
2. Remove the
Ink Supply Station (ISS) on page 355.
3. Remove the lower ink supply station PCA (see
Ink supply station PCAs on page 427).
326 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
Need help?
General
