HP Latex 300 Series

●
3.3.1 APS Pumps > Resets the APS Pump in cycles and hours.
Reset Scan-Aaxis Menu
Description
The purpose of this Service Utility is to check the service part usage and/or reset the life counter for the Scan
Axis:
●
3.4.1 Reset Belt Cycles: Resets the Belt cycles.
●
3.4.2 Tubes/Trailing Cables: Resets the cycles of the Trailing Cable and Ink Tubes.
●
3.4.3 SAX Motor Cycles: Resets the Scan Motor.
●
3.4.4 Encoder Strip: Resets the Encoder Strip.
Reset Carriage Menu
Description
The purpose of this Service Utility is to check the service part usage and/or reset the life counter for the
Carriage:
●
3.5.1 Carriage Cycles: Reset the cycles of the Carriage.
●
3.5.2 New Line Sensor: Reset the Line Sensor (hours).
●
3.5.3 Cutter Cycles: Reset the cutter cycles (number of times substrate has been cut).
●
3.5.4 Color Sensor: Reset the SOL (hours).
●
3.5.5 Carriage rod lubrication.
Reset Service Station
Description
The purpose of this Service Utility is to check the service part usage and/or reset the life counter for the
Service Station:
●
3.6.1 SS Rack Cycles: Resets rack motor.
●
3.6.2 Drop Detector: Resets Drop Detector (hours).
●
3.6.3 Complete Service Station: Resets the Service Station motor (cycles), Aerosol Fan (hours), Rack
Motor (Cycles), Split plate spittoon (liters), Aerosol Filters (liters), Spit plate DD (liters), Drop Detector
(hours).
●
3.6.4 Maintenance Cartridge.
●
3.6.5 Primer Cycles: Resets the Primer.
●
3.6.6 Spit roller.
4. Service Calibrations
4.1 Substrate Path
4.1.1 Substrate-Advance Calibration
Description
178 Chapter 4 Service Tests, Utilities, and Calibrations ENWW