6. Then test asks to remove the substrate. Press OK when done.
7. The front panel shows the diagnostic result. Press OK to finish the test and restart the printer.
5.2 Line Sensor Check
Description
The test checks the communication between the Line sensor and the Line sensor NVM.
Procedure
1. Go to Diagnostic test > 5. Carriage Menu > 5.2 Line Sensor Check.
2. The printer retrieves the Carriage Sensors PCA revision and displays it on the front panel. Press any key
to continue.
3. The printer checks that the Line Sensor NVM reads and writes correctly. To do this, the printer
temporarily writes a new serial number on the line sensor NVM then reads the new serial number to
verify that the change was made. The printer retrieves the line sensor serial and part numbers and
displays them on the front panel.
4. Press any key to finish the test.
6. Service Station
6.1 Shuttle Closed Loop
Description
This test checks the connection and functionality of the shuttle and the Service station motor. The Service
Station shuttle is the moving tray on which the Printhead Cleaning Cartridge is held.
Procedure
1. Go to Diagnostic tests > 6. Service Station Menu > 6.1 Shuttle Closed Loop.
2. When prompted by the front panel, manually move the Service Station to the front.
3. The front panel asks you to confirm that you have moved the Service Station, press OK.
4. Push the Service Station back a little to the rear, but not all the way, press OK.
5. Pull the Service Station a little to towards the front of the printer, but not all the way, and press OK.
6. Move the Carriage Assembly to the middle of the Scan axis, and press OK.
7. If the Service Station has moved automatically to the front of the printer press OK.
8. The front panel displays the results of the test in encoder units.
9. When prompted by the front panel, close the Window and press any key to finish the test.
6.2 Drop Detector Test
Description
The purpose of this test is to check the functionality of the drop detector.
Procedure
158 Chapter 4 Service Tests, Utilities, and Calibrations ENWW
To Next Page
Loading...
Need help?
General
