NOTE: When a component is replaced, the corresponding calibration is NOT automatically set to ‘NOT
DONE‘. This is because the printer does not know that there is a new part installed.
●
Drop Detector relates to the drop-detector or service-station calibration
●
Line Sensor relates to the line-sensor calibration
●
Line Sensor calibration X axis
●
Line Sensor calibration Y axis
Diagnostic log
This section displays the details of the calibrations that have been performed on the printer, it also contains
useful information, such as whether the particular calibration was successful or not.
Connectivity configuration
This page contains full details of the current configuration of the printer.
62 Chapter 2 Troubleshooting ENWW
To Next Page
Loading...
