5. Remove two T-10 screws to release the resistors from the datum position on the far right in front of
you.
6. Remove the resistors.
Installation
CAUTION: Make sure to reconnect the cables to the thermal switch properly: the double-wired O-ring cable
end in one thermal-switch leg and the other single O-ring cable end in the other leg. Otherwise you will
bypass the thermal-switch safeties and risk setting the printer on fire.
NOTE: There are two different resistors, ‘steady’ and ‘burst’. They have to be assembled together and their
joint is poka-yoke to avoid errors in terms of position.
NOTE: Make sure all cables are correctly routed.
ENWW Impinging air curtain resistors 275
To Next Page
Loading...
