Safety
The procedures described in this manual are to
be performed by HP-qualified service
personnel only.
Electrical shock hazard
• Ensure that the AC power outlet (mains) has a
protective earth (ground) terminal.
• Disconnect the printer (both power cords)
from the power source performing any
maintenance or servicing operation. The rear
switch is not the disconnecting device, unplug
all power cords before servicing the printer.
• Prevent water or any other liquids from
running onto electrical components or circuits,
or through openings in the enclosure.
Electrostatic discharge
See the beginning of Chapter 4 of this manual
for precautions you should take to prevent
damage to the printer circuits from
electrostatic discharge.
Safety symbols
Serious hazards leading to death, injury, or
damage may result if you do not take the
following precautions:
• The Warning symbol calls attention to a
procedure, practice, or the like, which, if not
correctly performed or adhered to, could result
in personal injury. Do not proceed beyond a
Warning symbol until the indicated conditions
are fully understood and met.
• The Caution symbol calls attention to an
operating procedure, practice, or the like,
which, if not correctly performed or adhered
to, could result in damage to or destruction of
part or all of the printer. Do not proceed
beyond a Caution symbol until the indicated
conditions are fully understood and met.
To Next Page
Loading...
Need help?
General
