7. Remove three T-8 screws that secure the Oiler Assembly to the side of the Carriage Assembly.
8. Remove the Oiler Assembly.
9. Remove the Absorber Foams from the cavities in the carriage.
NOTE: It is recommended to wear gloves.
Installation
NOTE: Before installing the Oiler Assembly, clean and lubricate the Carriage Rail following the standard
procedure.
NOTE: Insert the Absorbent Foams following the recommendations in the graph. Top pads have to be in
horizontal position and bottom pads popping out from the cavities.
If the Absorbent Foams are not inserted correctly, oil may reach the line sensor and prevent it from working.
Oil may also reach the print or the Printhead Cleaning Cartridge, which could damage the printheads.
324 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
