6. Slide the OMAS cable from the sideplate, pulling it carefully. Unroute the cable from both OMAS cable
clamps on the sideplate.
7. Unroute and remove the OMAS cable from the printer.
Installation
CAUTION: It is critical that the OMAS cable is correctly positioned in the vacuum beam so that it does not
block the vacuum chamber.
The following illustration shows a cross-section of the vacuum beam with the OMAS cable correctly routed to
avoid blocking the vacuum chamber.
1. Before you can start to install the OMAS cable you must first identify which end connects to which
component. The end of the cable that has a red line across its width connects to the OMAS (red line face
upwards). The other end should be connected to the OMAS controller card.
2. Carefully route the OMAS cable from the OMAS slot, sliding it through the OMAS foam.
402 Chapter 8 Removal and installation ENWW
To Next Page
Loading...
