11. Rotate the printer 90º so that the back of printer is on the bottom, and the bottom of the printer faces
to the front.
12. Place desiccant bags at the bottom of the printer.
13. Secure the four corners of the pallet.
14. Place the left foam packing part, and secure with adhesive tape.
15. Place the right foam packing part, and secure with adhesive tape.
16. Disassemble the legs.
17. Place the components of the TUR, loading table, and tension bar into their respective boxes. Secure the
boxes with adhesive tape.
ENWW Covering the printer 457
To Next Page
Loading...
