Lexmark C792 series - XX-Staging Motor Error Service Check

Diagnostic information 2-87
5062
Go Back
Previous
Next
147.xx—Staging motor error service check
Step Questions / actions Yes No
1 Turn the printer off, and open the system
board shield. Check the cable in connector
JSTAG1 (staging motor cable) for proper
connection to the system board.
Is the cable properly connected?
Go to step 2. Reseat the cable.
2
Check the cable for damage.
Is the cable damaged?
Replace the staging motor
cable. See “Staging paper
path reference edge
assembly removal” on
page 4-142 to access the
cable.
Go to step 3.
3
Remove the LVPS. See “Low-voltage
power supply (LVPS) removal” on
page 4-86. Check the cable connection to the
motor.
Is the cable connected correctly to the
staging motor?
Go to step 4. Reseat the cable.