Lexmark C792 series - HTU Sensor (Second) Removal; HTU Sensor Cable (Bin-Full Send and Receive) Removal

4-324 Service Manual
5062
Go Back
Previous
Next
HTU sensor (second) removal
1. Remove all output options from the printer.
2. Remove the HTU lower redrive guide. See “HTU lower redrive guide removal” on page 4-297.
3. Press the tabs to release the sensor, and then disconnect the cable to remove the sensor.
HTU sensor cable (bin-full send and receive) removal
1. Remove all output options from the printer.
2. Remove both bin-full sensors. See “HTU card (bin-full send card and lens) removal” on page 4-288
and “HTU card (bin-full receive card and lens) removal” on page 4-287.
3. Route the cable through the frame.