2-150 Service Manual
5062
Double feed (550-sheet/2000-sheet input option) service check
5
1. Turn the printer off.
2. Disconnect the cables in J5, JFSR1,
JHVPS, JCM1, JITM1, JKI1, JOOPT1,
and JYF1.
3. Connect the JLVPS1 cable to the system
board.
4. POR the printer.
Is the printer still dead?
Contact your next level of
support.
Go to step 6.
6
Connect one cable at a time, and POR the
printer.
Is the failing part found?
Replace the failing part. Contact you next level of
support.
Step Questions / actions Yes No
1 Check if the media supported and
environmental specification are supported by
this machine. See “Environment” on
page 1-5 and “Supported paper sizes,
types, and weights” on page 1-7 to check
the printer specifications.
Are the media and environment
supported?
Go to step 3. Replace the media.
2
Check the pick rolls for contamination and
wear.
Are the pick rolls free of contamination
and wear?
Go to step 3. For 550-sheet input option:
Replace the pick roll
assembly. See “550-sheet
tray pick roll assembly
removal” on page 4-180.
For 2000-sheet input
option: Replace the pick
roll assembly. See “2000-
sheet high-capacity
feeder pick roll assembly
removal” on page 4-224.
Step Questions / actions Yes No
To Next Page
Loading...
