Repair information 4-239
5062
5-bin mailbox diverter solenoid removal
See“5-bin mailbox assembly (interior)” on page 7-37 for the part number.
1. Remove the mailbox from the printer.
2. Remove the 5-bin mailbox feed motor with plate. See “5-bin mailbox feed motor with plate removal” on
page 4-241.
3. Remove the four screws (A) securing the diverter plate.
4. Remove the screw (B) of the deflector gate solenoid you need to remove.
5. Carefully unroute the deflector gate solenoid cables from the cable clips under the top cover.
6. Disconnect the appropriate deflector gate solenoid cable from the controller card.
7. Route the cable through the frame to remove the assembly.
To Next Page
Loading...
