Diagnostic information 2-127
5062
456.01 - 456.08—Finisher stapler home sensor error service check
3
Remove the Finisher/Stacker front cover. See “Finisher
or stacker front cover removal” on page 4-260.
Check the cable in the indicated connector.
Is the cable proper connected?
Go to step 4. Reseat the
connector.
4
Replace the Finisher/Stacker sensor (pass thru). See
“Finisher or stacker sensor (pass thru) removal” on
page 4-275.
Does the error reoccur?
Replace the
Finisher/Stacker
controller card.
See “Finisher
or stacker
controller card
assembly
removal” on
page 4-258.
Problem solved.
Step Questions / actions Yes No
1 1. Bring the printer up in Diagnostics menu (turn off the
printer, press and hold 3 and 6, turn on the printer,
and hold the buttons until the splash screen appears).
2. Navigate to INPUT TRAY TESTS > Feed Test.
3. Select Tray 1.
4. Select Single.
Does the error reoccur?
Go to step 2. Problem solved.
2
Replace the Finisher stapler unit assembly. See
“Finisher stapler unit assembly removal” on
page 4-281.
Does the error reoccur?
Replace the
Finisher/Stacker
controller card.
See “Finisher
or stacker
controller card
assembly
removal” on
page 4-258.
Problem solved.
Step Questions / actions Yes No
To Next Page
Loading...
