4-248 Service Manual
5062
5-bin mailbox output bin roller removal
1. Remove the mailbox option from the printer.
2. Remove the 5-bin mailbox output deflector for the roller you want to remove.
3. Rotate the clips forward that are holding the roller in place.
4. Lift the roller out of the mailbox.
5-bin mailbox output bin sensors removal
See“5-bin mailbox assembly (interior)” on page 7-37 for the part number.
1. Remove the mailbox from the printer.
2. Remove the rear cover. See “5-bin mailbox rear cover removal” on page 4-249.
3. Press in the tabs to pop out the sensor you need to replace.
4. Disconnect the cable to remove the sensor.
Installation note: When you put the sensor in place, be sure the side with the cable connector faces the printer
circuit board.
To Next Page
Loading...
