Lexmark C792 series - Finisher or Stacker Sensor (Bin-Full Receive) Removal

Repair information 4-271
5062
Go Back
Previous
Next
Finisher or stacker sensor (bin-full receive) removal
See “Finisher/High-capacity output stacker assembly” on page 7-25 for the part number.
1. Remove the option from the printer.
2. Remove the option rear cover. See “Finisher or stacker rear cover removal” on page 4-269.
3. Remove the two screws (A) securing the sensor.
4. Disconnect the cable, and remove the sensor.