3-24 Service Manual
5062
Cal Ref Adj
Warning: This setting should not be changed without specific instructions from the next level of support.
Cal Ref Adj adjusts the printer’s toner density and alignment setting.
Par 1 Strobe Adj
Parallel Strobe Adjustment enables you to change the amount of time the strobe is sampled in order to
determine if data is available on the parallel port. Increasing the value increases the amount of time by 50 ns per
increment. Decreasing the value decreases the sample time by 50 ns per increment.
Touch Back to return to the Diagnostics menu.
EP SETUP
EP Defaults
The EP Defaults is used to restore each of the printer settings contained in the EP Setup menu to their factory
default value.
To restore the EP Setup settings to factory defaults, select Restore. To exit the menu without restoring the
settings to the factory defaults, touch Back.
Fuser Temp
Warning: This setting should not be changed without specific instructions from the next level of support.
DC Charge Adjustment
Warning: This setting should not be changed without specific instructions from the next level of support.
Dev Bias Adj
Warning: This setting should not be changed without specific instructions from the next level of support.
Transfer Adjust
Warning: This setting should not be changed without specific instructions from the next level of support.
Op Point Boost
Warning: This setting should not be changed without specific instructions from the next level of support.
EVENT LOG
Display Log
Display Log shows the message that appeared on the operator panel for each event in the log, starting with the
most recent. Use the touch-screen arrows to scroll through the log entries. To see more in-depth information
about each event, print the event log using the Print Log menu item.
Touch Back to return to the EVENT LOG menu.
To Next Page
Loading...
Need help?
General
