Lexmark C792 series - Page 220

3-8 Service Manual
5062
Go Back
Previous
Next
Multi-Purpose Feeder
Print Quality Pages See “Print Quality Pages” on page 3-14
HARDWARE TESTS
Panel Test See “Panel Test” on page 3-14.
Button Test See “Button Test” on page 3-14.
DRAM Test See “DRAM Test” on page 3-14.
Serial Wrap 1 (if installed) See “Serial Wrap Test” on page 3-15.
USB HS Test Mode See “USB HS Test Mode” on page 3-16.
Beacons Test See “Beacons Test” on page 3-16.
DUPLEX TESTS (if installed)
Quick Test See “Duplex Quick Test” on page 3-16.
Top Margin See “Duplex Top Margin Offset” on page 3-16.
INPUT TRAY TESTS
Feed Tests See “Feed Test” on page 3-17.
Sensor Tests See “Sensor Test” on page 3-17.
OUTPUT BIN TESTS
Feed Tests See “Feed Test” on page 3-18.
Feed To All Bins See “Feed to All Bins” on page 3-18.
Sensor Test See “Sensor Test” on page 3-18.
Diverter Test See “Diverter Test” on page 3-19.
Mechanical Test See “Mechanical Test” on page 3-19.
BASE SENSOR TEST See “BASE SENSOR TEST” on page 3-21.
FINISHER TESTS
Staple Test See “Staple Test” on page 3-19.
Hole Punch Test See “Hole Punch Test” on page 3-19.
Feed Test See “Finisher Feed Test” on page 3-20.
Sensor Test See “Finisher Sensor Test” on page 3-20.
Mechanical Test See “Mechanical Test” on page 3-19.
DEVICE TESTS (if installed)
Quick Disk Test See “Quick Disk Test” on page 3-21.
Disk Test/Clean See “Disk Test/Clean” on page 3-22.
Flash Test See “Flash Test” on page 3-22.
PRINTER SETUP
Defaults See “Defaults” on page 3-22.
Prt Color Pg Count See “PAGE COUNTS” on page 3-23.
Prt Mono Pg Count
Perm Page Count
Serial Number See “Serial Number” on page 3-23.
Engine Setting 1-4 See “Engine Setting x” on page 3-23.
Model Name See “Model Name” on page 3-23.
Configuration ID See “Configuration ID” on page 3-23
.
Reset Color Cal See “Reset Color Calibration” on page 3-23.
Cal Ref Adj See “Cal Ref Adj” on page 3-24.