Repair information 4-157
5062
Installation notes:
• Be sure to reinstall any toroids you had to remove.
• Some connectors have the same number of pins, so be sure each cable is connected to the correct
connector. For diagrams and tables showing where each cable connects, see “Locations” on page 5-1.
Note: The four cables can be plugged into any of the four connectors (JPK1, JPM1, JPY1, and JPC1) on
the board.
Note: Pull the four cables into the system board cage area as far as possible so that they would not get
caught in the EP drive motors.
To Next Page
Loading...
