7-60 Service Manual
5062
27S2839 Taptite M3 x 6 mm
slotted hex black
System board shield to system board cage 2
88A0001 MACH M3X0.5-6G
4LG
550-sheet drive assembly to 550-sheet drawer 1
88A0121 M3.5 x 6 Machine
Panhead
Standoff to HVPS board 1
88A0212 Taptite Metal
M3.5 x 6 mm PAN
C-datum guide/F-thermister assembly to frame 4
Cartridge contact block assembly to front frame 3
Cartridge memory block assemblies to rear frame, 2 per assembly 8
Cartridge rail assemblies to frame, left and right, 1 per rail 8
EP drive assembly to frame 8
Exit cooling fan duct assembly to frame 1
Fuser drive assembly to frame 3
Ground cables to frame 4
LVPS to frame 3
Media tray rails to bottom plate, 1 per rail 2
Post to HVPS board and frame plate above it 2
Rear cover to system board cage and frame 2
Rear upper cover to rear cover 2
Redrive motor to frame 2
Right cover to lower front frame 1
System board cage to support 1
Top cover to top frame 3
88A0231 M3x5 taptite 2000-sheet bracket to frame 4
2000-sheet controller card housing to 2000-sheet drawer 3
2000-sheet jam clearance cover to 2000-sheet drawer 4
2000-sheet jam clearance top cover to 2000-sheet drawer 1
2000-sheet led bracket to 2000-sheet drawer 2
2000-sheet left anti-tip latch assembly to 2000-sheet drawer 2
2000-sheet right anti-tip latch assembly to 2000-sheet drawer 2
cave light to 2000-sheet drawer 2
Screw identification table (continued)
P/N Screw type Location Qty
To Next Page
Loading...
