2-52 Service Manual
5062
Load Manual <size> If paper loaded is in the manual feeder, the job continues. If paper is not in the feeder,
pressing Select indicates to the printer it should search for a source with the proper size.
Additional messages may include:
• Show Me—The printer will present instructions.
• Cancel Job—The printer job can be canceled.
Load Manual <type>
<size>
If paper loaded is in the manual feeder, the job continues. If paper is not in the feeder,
pressing Select indicates to the printer it should search for a source with the proper type and
size.
Additional messages may include:
• Show Me—The printer will present instructions.
• Cancel Job—The printer job can be canceled.
Paper Changes Needed Make sure the correct paper size is loaded in the paper tray.
PC Unit Exposure
Warning
This warning occurs when the front door is left open too long. Close the front door to prevent
damage to the PC unit. Select Tell me more for further information.
Remove All Color
Supplies
If Color Lockout mode is enabled, this message appears (unless the printer is in Diagnostics
Menu or Configuration Menu).
Remove Paper
Standard Bin
The standard output bin is full. Remove the media to continue.
Remove Packaging
Material
If packaging material is detected by the printer, Check all areas, Check <area name>, or
Check <number of> areas may appear. Press Select to continue.
Restore Held Jobs
Go/Stop?
If the printer detects Print and Hold (or parked) jobs stored on the hard disk during Power-On
Self Test (POST). Choices are:
• Restore—Print jobs are restored, and Restoring Held Jobs x/y, where x is the number
of the job restored and y is the total number of jobs to restore. You can quit restoring, and
the remainder of the jobs will remain on the disk, but cannot be accessed until they are
restored at the next POR.
• Do not restore—Held jobs will remain on the disk, but cannot be accessed until they are
restored at the next POR. Held jobs may not be restored appears.
• Tell me more—Additional information is available
Securely Clearing Disk
Space
Disk wiping process is recovering disk space. The message clears when all memory blocks
are cleared.
Tray Length Guide
Missing
Replace the tray length guide.
Unsupported USB
device, Please Remove
Remove the unrecognized device to continue.
Unsupported USB hub,
Please Remove
Remove the unrecognized device to continue.
Unsupported Mode Unplug camera and change it to a mode where the camera can access PictBridge. Plug the
camera back in to continue.
Unsupported Disk Remove the unsupported disk to continue.
Error code Action
To Next Page
Loading...
Need help?
General
