Lucent Technologies CBX 3500 - Page 13

Contents
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 xiii
Beta Draft Confidential
Configuring Feeder Logical Ports............................................................................8-16
General Attributes .............................................................................................8-18
Administrative Attributes..................................................................................8-20
ATM Attributes.................................................................................................8-23
ATM FCP Attributes (CBX 500 and CBX 3500).............................................8-26
QoS Tab.............................................................................................................8-28
ILMI/OAM Tab.................................................................................................8-30
NTM Tab...........................................................................................................8-32
Configuring ATMoMPLS Trunk Logical Ports ......................................................8-34
ATMoMPLS Trunk Logical Port General Attributes .......................................8-35
ATMoMPLS Trunk Logical Port Administrative Attributes............................8-37
ATMoMPLS Trunk Logical Port QoS Attributes.............................................8-40
ATMoMPLS Trunk Logical Port Traffic Descriptor Attributes.......................8-42
Configuring the ATMoMPLS Trunk.......................................................................8-43
Chapter 9 Configuring ATM Over MPLS Gateway Solution on CBX 3500
ATM Over MPLS Application Overview..................................................................9-3
ATMoMPLS Trunking........................................................................................9-3
Layer 2 Tunnel Over an MPLS Core Network ...................................................9-3
Supported Modules.......................................................................................9-4
PWE3 Over an MPLS Core Network..................................................................9-5
Supported Modules.......................................................................................9-5
Network-wide MPLS Settings...................................................................................9-7
Configuring MPLS Affinities..............................................................................9-7
Configuring MPLS Tunnel Hop Lists.................................................................9-8
Configuring IntServ and DiffServ Profiles .......................................................9-10
Creating IntServ Profiles ............................................................................9-10
Creating Diffserv Profiles...........................................................................9-13
Configuring a Layer 2 Tunnel Over MPLS Core Network .....................................9-16
Configuring Node-based MPLS Parameters.....................................................9-17
Adding a PPP LPort ..........................................................................................9-19
General Attributes for POS LPorts.............................................................9-21
Administrative Attributes for POS LPorts..................................................9-22
QoS Attributes for POS LPorts...................................................................9-23
Trap Control Attributes...............................................................................9-26
MPLS Attributes for POS LPorts ...............................................................9-28
Congestion Control Attributes....................................................................9-30
Point to Point Attributes .............................................................................9-31
Adding an IP LPort............................................................................................9-32
Configuring RSVP-TE on IP LPorts ..........................................................9-34
Specifying the IP Interface Address..................................................................9-38
Configuring OSPF IP Parameters......................................................................9-39
Configuring a PSN Tunnel................................................................................9-43
General Tab Attributes................................................................................9-45
RSVP Signalling Attributes........................................................................9-47
Configuring a Layer 2 Tunnel...........................................................................9-51
Layer 2 Tunnel General Attributes.............................................................9-52
Layer 2 Tunnel ATM Attributes.................................................................9-54