ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 6-1
Beta Draft Confidential
6
Working with the ATM FCP
You can configure the ATM Flow Control Processor (FCP) on an input/output module
(IOM) after you set the module’s attributes. This chapter describes how to configure
the FCP. In addition, this chapter addresses frequently asked questions about the FCP.
This chapter describes the following topics and tasks:
• “Configuration Process Overview” on page 6-2 outlines the major steps to
configure ATM FCP.
• “Enabling the FCP” on page 6-2 describes specific steps to enable ATM FCP.
• “Downloading Buffer Threshold and Rate Profile Tables” on page 6-8 describes
how to load rate profile tables into the FCP.
• “Setting Logical Port FCP Attributes” on page 6-10 describes how to configure
additional ATM FCP attributes for the logical port.
• “Frequently Asked Questions About the FCP” on page 6-14 provides answers to
commonly asked questions about the ATM FCP.
To Next Page
Loading...
Need help?
General
