ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 10-1
Beta Draft Confidential
10
Configuring ATM PVCs
This chapter describes how to configure the following types of Lucent ATM
permanent virtual circuits (PVCs):
• Point-to-point (page 10-13)
• Frame Relay-to-ATM Service/Network Interworking (page 10-40)
• Redirect (page 10-34)
• Point-to-multipoint (PMP) (page 10-71)
In addition, this chapter explains how to manually define PVCs and use the Move
Circuit function.
See Chapter 11, “Configuring Management Paths” for information about management
PVCs, management SPVCs, and management redirect PVCs.
Note – For information about the virtual circuit (VC) capacity for various elements on
a B-STDX, CBX, or GX switch, see the appropriate Switch Software Release Notice
(SRN).
To Next Page
Loading...
Need help?
General
