ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 16-1
Beta Draft Confidential
16
About SVCs
This chapter describes how to use switched virtual circuits (SVCs). With SVCs,
connections are not predefined as they are for permanent virtual circuits (PVCs).
Instead, end stations use a signaling protocol to indicate to the ATM network the
endpoint to which it should route the SVC request (called party). To support SVC
services, each user endpoint is assigned a unique address which identifies the endpoint
and enables the network to route the SVC request.
Note – You cannot configure ATM SVCs on B-STDX 9000 switches or GX 550 ES
logical ports.
To Next Page
Loading...
Need help?
General
