ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 17-1
Beta Draft Confidential
17
Configuring SVC Parameters
This chapter contains procedures to perform the following tasks:
• Configure switched virtual circuit (SVC) attributes, such as Connection ID.
• Configure node and port prefixes to route SVC requests to a specific node or
logical port. With node and port prefixes, you may take advantage of address
registration.
• Configure the port user part of an address (DTE ports only). Address registration
combines the port user part with a node or port prefix to route the SVC request.
• Configure SVC port addresses to route SVC requests to a specific logical port
when the attached network device does not support address registration.
• Configure a network ID to uniquely identify an inter-exchange carrier (IXC).
Note – You cannot configure ATM SVCs on B-STDX 9000 switches or CBX 500
Frame-based modules.
The B-STDX 9000 switch does not support the ATM Private Network-to-Network
Interface (PNNI) routing protocol.
For information about using Open Shortest Path First (OSPF) name aggregation to
minimize prefix and address memory consumption in Lucent network switches, see
Appendix G, “OSPF Name Aggregation.”
To Next Page
Loading...
Need help?
General
